The ICP 100 software can be used to configure all modules in the Q.series, e.series and ISM series over the RS485 serial interface and adapt them to the specific requirements.

After a bus scan, all connected modules are shown clearly regard­less of the baud rate. Four menu tabs provide a good overview and quick, intuitive use of the software. Complete configuration and storage in a file is possible even without modules connected when using the offline mode. ICP 100 is an integral part of test.commander however can also be run as a stand-alone program, and is available without test.commander for systems where the e.series and Q.series measurement modules are to be used as remote I/O for another legacy system, typically using the native Modbus or Profibus communication ability of the modules.